PDA

View Full Version : wiring a Iwaki mx-100


medican
07-28-2006, 08:43 PM
Hey peoples........
I just got a new mx-100 Iwaki and yes @#$##$ no power cord. Could you give me some help wiring it please. I will be using 30 amp cord, took off the power box cover found the ground marked G...lol , but the poss and neg I dont want to mess up.

Thanks

Denis
07-29-2006, 02:55 AM
If there is white and black terminal then use black for hot lead (smaller one in the receptacle) and white for neutral. There is no positive & negative it's alternating current.
If it's not marked then it don't matter witch way it goes.
You can always check iwaki web.
http://www.iwakiwalchem.com/nav/cm.aspx?cmid=35

Denis
07-29-2006, 03:14 AM
Well After looking at the web myself, no help there.
Why don't you take a pic of the connector and we can try to figure it out for ya.
It appears that these are a industrial hard wire application pumps, hence no cord. Manual just says wire accordingly to elec. code.

medican
07-29-2006, 03:56 PM
I think I got it.......

Thanx for your help