Neptune FMK ONLINE!

[Reef Supplies]

Hello everyone,

We have added the FMK online, we should start shipping these on Tuesday!



Here is the link:

http://www.reefsupplies.ca/online-st...g-Kit-FMK.html

There is a limited amount! :-( if by the time you get to it you see them marked as backorder, do not order unless you are ready to wait 2-3 weeks.

Have a great weekend

[Bugger]

Does this come with a power bar.
Your site shows a power bar for this
I don't understand why this would have to be plugged into an outlet.

[Reef Supplies]

Originally Posted by Bugger

Does this come with a power bar.
Your site shows a power bar for this
I don't understand why this would have to be plugged into an outlet.

Huh? Where do you see that? It comes with....

FMM - FLUID MONITORING MODULE

1'' FLOW SENSOR (FS-100)

TWO 1/2'' FLOW SENSORS (FS-50)

TWO 1'' UNIONS

FOUR 1/2'' ADAPTERS

Thanks!

[Bugger]

http://www.reefsupplies.ca/online-st...W-for-FMM.html
Its right here
But how would you monitor without fusion.
The kit does not come with this as you already explained
What is this for then?

[kyl]

It's so you can run something off of the 24v DC port (the PMUP, solenoid, etc). Sold as-is the FMK has no use for the 24v port, it's just running flow sensors, but since the module itself is multi-function it's there if you want. The only thing that is 'no apex required' is their ATO version of the FMM kit (ATK) with the dual optical sensors, as it comes with a PMUP pump and the wall wart dc adapter shown.

In stand alone mode (no Apex required) the FMM is setup to accept the sensors in a preprogrammed setup. Sensor wires come prelabeled 1 & 2, just match them up and plug them in. Port 3 is designated for extra high level cut off in place of the float valve if you have no room for it while port 4 is for ATO Reservoir low level sensor.