My addiction 300DD - Page 50

PurpleMonkey · #**491** 03-01-2013, 04:26 AM

I'm not useful for much, but I can usually lift heavy-ish things if you need

mikepclo · #**492** 03-01-2013, 10:20 PM

Damn Rich, Sorry to hear what happened. I'm only few Hwy exits away if you need anything.

Reef Pilot · #**493** 03-01-2013, 11:38 PM

Wow, I'm in Maiu right now, and thought I'd take a peek at Canreef, and this is what I see!! Glad to hear it's under control, though, for now. I would offer my help too, if needed. I will be back end of next week.

You have a genuine treasure there, Rich, with your tank and frags. Would be a terrible loss if you had a crash. Hopefully, it will end well.

Again, if I can be of any help, please let me know.

Bblinks · #**494** 03-05-2013, 09:06 PM

Quote:

Originally Posted by PurpleMonkey

I'm not useful for much, but I can usually lift heavy-ish things if you need

lmao, thanks for the offer.

Quote:

Originally Posted by mikepclo

Damn Rich, Sorry to hear what happened. I'm only few Hwy exits away if you need anything.

Its okay Mike, I gotta it all taken care of now.

Quote:

Originally Posted by Reef Pilot

Wow, I'm in Maiu right now, and thought I'd take a peek at Canreef, and this is what I see!! Glad to hear it's under control, though, for now. I would offer my help too, if needed. I will be back end of next week.

You have a genuine treasure there, Rich, with your tank and frags. Would be a terrible loss if you had a crash. Hopefully, it will end well.

Again, if I can be of any help, please let me know.

Thanks very much Walter. I will do my best to get thing back on track again.

Bblinks · #**495** 03-05-2013, 09:37 PM

So guys, it has been a week and a half-ish since the sump started leaking. I have finally got every thing circulating again. I must say it has been a trail and tribulation week for me. So many late nights looking at the tank and thinking about shutting it down but I just couldn't do it.

Now everything is running again, I'll have to stablize the whole system. Last night when I check the parameters it was at a all time low.
Calcium 320
Alkalinity 5.2
Magnesium 1150

I also had to clean out my biopellet as the whole bacteria mass has died off. I washed the pellets then palced them into some ro water over night and reused it. I didn't think it was a big deal to reuse, seem like a waste to toss it but I could be wrong...

Anyways.... here is the fun part, New Sump.

The new sump is built by H2O in Victoria and let me tell you it is beefy. The measurement on it is 50X30X16.5 and it's made from 1/2 inch glass all around.

My wife was nice enough to pick it up for me. Props to Derek at H2O for helping her lift it into the rav. I had a few friends over to help me move this little beast into position but man she is heavy. I under estimated the width of my door and had a real pain in the butt time getting it through but we did it.

Here is a picture of Greg ZZ4 helping me cut off the old bulk head. Thanks man!

Here is the sump dry fitted.

Finally got her filled yesterday.

When I was filling the water we sprung a little leak out of the union by the reefflo and naturally its the other side of the ball valve. I was cursing like a sailor. It didn;t matter how hard I cranked that nut down it stil leaked. As I was getting the bat out I realize the friken ORING wasn't in there. FML, got my panties in a knot for no reason.

Lesson of the week: Patience (or forbearing) is the state of endurance under difficult circumstances, which can mean persevering in the face of delay or provocation without acting on annoyance/anger in a negative way; or exhibiting forbearance when under strain, especially when faced with longer-term difficulties. Patience is the level of endurance one can take before negativity

Bblinks · #**496** 03-05-2013, 09:49 PM

What do you guys think, should I put my UV back in?

hillegom · #**497** 03-05-2013, 09:54 PM

Wow, problems right to the end
Glad the hardware is all sorted out now.
Just the water left, and for you that shouldn't be a problem.
Good work

kien · #**498** 03-05-2013, 09:56 PM

Quote:

Originally Posted by Bblinks

I also had to clean out my biopellet as the whole bacteria mass has died off. I washed the pellets then palced them into some ro water over night and reused it. I didn't think it was a big deal to reuse, seem like a waste to toss it but I could be wrong...

It'll be fine, I've bought so many people's unwanted and used biopellets over the past 3 years it's not even funny! My reactor currently has 3 different types from 3 different people tumbling. All I do is what you did, rinse, dry and store for use later.

lastlight · #**499** 03-05-2013, 10:04 PM

Quote:

Originally Posted by Bblinks

What do you guys think, should I put my UV back in?

do everything you did before except the part where your sump leaks. proof is in the pudding.

Bblinks · #**500** 03-05-2013, 10:05 PM

Quote:

Originally Posted by kien

It'll be fine, I've bought so many people's unwanted and used biopellets over the past 3 years it's not even funny! My reactor currently has 3 different types from 3 different people tumbling. All I do is what you did, rinse, dry and store for use later.

Kien, you biopellet whore. just kidding!

Thanks for the reply. Any thoughts on the UV?