Cannot Program Radion G1 - Help

[asylumdown]

I've unfortunately had more experience than I wish I did dealing with programming Radions. Generally speaking a factory reset after moving a light from one group to another seems to be necessary to avoid things like this. Thankfully it's only one light so it's pretty simple to do, and doesn't hurt the light at all. My advice would be to delete the group, factory reset the light and start from scratch. It will more than likely solve the issue.

[HaZRaTTy]

Originally Posted by asylumdown

I've unfortunately had more experience than I wish I did dealing with programming Radions. Generally speaking a factory reset after moving a light from one group to another seems to be necessary to avoid things like this. Thankfully it's only one light so it's pretty simple to do, and doesn't hurt the light at all. My advice would be to delete the group, factory reset the light and start from scratch. It will more than likely solve the issue.

Factory reset and nothing, I will be calling ecotech tomorrow it they are open I also emailed them tonight. We will see I guess

[asylumdown]

Ok well that sucks balls. EcoTech is not open on the weekends, and their office is in the east so if you call on Monday make sure to do it before 3 Alberta time.

[Reef Pilot]

Have you tried the Ecosmart Config Utility (needs to be downloaded and run)? And are you running the right mode on they lights to match your program? Green light is the natural mode, where blue is the artificial.

Took me a bit at the beginning to figure out the software (not the most intuitive), but no problems after that.