Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 04-05-2008, 03:57 PM
Gools's Avatar
Gools Gools is offline
Member
 
Join Date: May 2004
Location: Vernon
Posts: 520
Gools is on a distinguished road
Default Warming RO water?

My RO feed water is freezing, just looking for some ideas on how to warm it up. I have heard of using a bucket with water and a heater in it, only problem is you would need alot of tubing for the water to have a chance to warm up, and with more tubing you lose pressure. Is there any other methods to warm the water?
Reply With Quote
  #2  
Old 04-05-2008, 04:06 PM
banditpowdercoat's Avatar
banditpowdercoat banditpowdercoat is offline
Member
 
Join Date: Oct 2007
Location: 100 mile hse BC
Posts: 2,568
banditpowdercoat is on a distinguished road
Default

Make RO in a bucket, with heate in it. One bucket at a time. Are you planing a large water change? Basically need a bucket large enough to hold all the water you want to change, or change the water one smaller bucket at a time
__________________
Dan Pesonen


Umm, a tank or 5
Reply With Quote
  #3  
Old 04-05-2008, 05:13 PM
Myka's Avatar
Myka Myka is offline
Moderator
 
Join Date: Mar 2004
Location: Saskatoon, SK.
Posts: 11,268
Myka will become famous soon enough
Default

Are you talking top up or waterchanges? Either way...bucket with heater.
__________________
~ Mindy

SPS fanatic.

Reply With Quote
  #4  
Old 04-05-2008, 05:25 PM
banditpowdercoat's Avatar
banditpowdercoat banditpowdercoat is offline
Member
 
Join Date: Oct 2007
Location: 100 mile hse BC
Posts: 2,568
banditpowdercoat is on a distinguished road
Default

I dont warm for top-ups. But then, only using 1/2g for TU, added to sump, doesnt change tank temp
__________________
Dan Pesonen


Umm, a tank or 5
Reply With Quote
  #5  
Old 04-05-2008, 05:34 PM
Psyire's Avatar
Psyire Psyire is offline
Member
 
Join Date: Dec 2004
Location: Northern Alberta
Posts: 605
Psyire is on a distinguished road
Default

The only thing you can do is add a pump and make sure your pressure into your RO unit is 65 psi constantly. (if it is already then forget the pump)

It would cost you a lot more money to warm your feed water with a heater than it would to simply waste more water. (electricity is much more expensive than water)

One other possible option is to coil your RO feed tubing in your sump. This will cool your tank water as well as heat your RO feed water. You must be careful not to cool your tank water too much though otherwise your heater will run and you are back to square one.
Reply With Quote
  #6  
Old 04-05-2008, 07:13 PM
KrazyKuch's Avatar
KrazyKuch KrazyKuch is offline
Member
 
Join Date: Dec 2004
Location: Calgary S.W
Posts: 656
KrazyKuch is on a distinguished road
Send a message via MSN to KrazyKuch
Default

You could always tap into you hot water feed line as put a valve and then take it to you RO aswell....this way you can add a little hot water to bring them temp up!
__________________
500G Mixed Reef



__________________________________
Electrician, Electronics Technician, I can help with any electrical questions you might have!!
__________________________________

Kevin
Reply With Quote
  #7  
Old 04-05-2008, 08:30 PM
Richard_Dicosimo Richard_Dicosimo is offline
Member
 
Join Date: Dec 2004
Location: Calgary
Posts: 298
Richard_Dicosimo is on a distinguished road
Send a message via MSN to Richard_Dicosimo
Default

im not certain but im sure that i read your ro unit will work better with cold water then hot so dont tap your hot water line.

Richard
Reply With Quote
  #8  
Old 04-05-2008, 08:46 PM
Gools's Avatar
Gools Gools is offline
Member
 
Join Date: May 2004
Location: Vernon
Posts: 520
Gools is on a distinguished road
Default

RO membranes are suppose to produce better around 77degrees water temp. I'm getting major condensation on all my RO lines, which has never happened before, so my water is very cold, which will cause you to lose performance. Right now I am getting around 80 psi to my membrane.
Reply With Quote
  #9  
Old 04-05-2008, 10:09 PM
KrazyKuch's Avatar
KrazyKuch KrazyKuch is offline
Member
 
Join Date: Dec 2004
Location: Calgary S.W
Posts: 656
KrazyKuch is on a distinguished road
Send a message via MSN to KrazyKuch
Default

Correct they work best in that 25 degree Celcius temp range and the last time I checked the temp of the water coming out of my tap it was like around 16 degree's celcius
__________________
500G Mixed Reef



__________________________________
Electrician, Electronics Technician, I can help with any electrical questions you might have!!
__________________________________

Kevin
Reply With Quote
  #10  
Old 04-05-2008, 10:26 PM
Black Phantom's Avatar
Black Phantom Black Phantom is offline
Member
 
Join Date: Feb 2006
Location: Calgary
Posts: 331
Black Phantom is on a distinguished road
Default

This might not work for everyone but I run my supply line through my sump.Being that I heat the water for the tank I figured why not use it. I also make sure I do a five minute flush of the membrane once a week. It seams to add to the life of my RO.
__________________
250 gal display tank plumbed directly to my wallet
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 07:39 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.