Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > DIY

Reply
 
Thread Tools Display Modes
  #1  
Old 12-27-2019, 04:16 AM
chi chi is offline
Member
 
Join Date: Jan 2013
Location: Burnaby
Posts: 93
chi is on a distinguished road
Default Sharpen your flipper magnet algae scraper

I recently tried to sharpen this particular algae scraper and it was a great success. I hope this short article is helpful for you guys.


Things you will need:
- Whetstone
- flat surface
- elbow grease


This particular scraper has an angle that is set into the unit, so follow that angle. It is identical to sharpening a wood scraper.

First you sharpen the edge like shown below, with the scraper on the magnet still and run it across the stone as you would scraping the glass.

And now take off the blade and hone the side to get the burr back to that edge.


Then finally alternate pass on the edge and the side of the blade a total of 10-15 times.

As you can see in the picture, the edge is much bigger than when I got it, but it scrapes algae off like butter again.



Hope you guys enjoyed this tip and never to buy another scraper tip replacement again.

Cheers


p.s., I'm not able to resize the images using <IMG=100x50></IMG> Not sure what's going on here.
Reply With Quote
  #2  
Old 04-10-2020, 04:33 AM
LifeIsGreat LifeIsGreat is offline
Member
 
Join Date: Mar 2019
Location: Moose Jaw
Posts: 102
LifeIsGreat is on a distinguished road
Default

Good advise. I used to work at a car dealership and I used a razor blade to clean stickers and stuff off the windows. A dull blade will scratch the glass, but a sharp one will not (unless the user really screws up).
Reply With Quote
  #3  
Old 04-13-2020, 08:28 PM
chi chi is offline
Member
 
Join Date: Jan 2013
Location: Burnaby
Posts: 93
chi is on a distinguished road
Default

Glad you enjoyed it!
Reply With Quote
  #4  
Old 04-14-2020, 03:29 AM
Thanhk87 Thanhk87 is offline
Member
 
Join Date: Jan 2019
Location: Vancouver
Posts: 29
Thanhk87 is on a distinguished road
Default

Wouldn't it it leaves mark on your glass? I mean its like putting a knife to the glass. I mean u need it to be perfect. I know cause i sometime sharpen knife for my work and its never perfect. Even with 8000 grid

Sent from my SM-G960W using Tapatalk
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 08:19 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.