Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 05-28-2018, 10:45 PM
takeastabatit22 takeastabatit22 is offline
Member
 
Join Date: May 2017
Location: Coquitlam
Posts: 88
takeastabatit22 is on a distinguished road
Default NO3:PO4

Any one out their use red see nopox?
I used it to a year no problems. Then weaned my self off it. After a couple mouths I couldn't maintain low no3. So I started back on it. As expected. It's doing a good job. But I'm am getting cyanobacteria again. I noticed while off it was all gone. Now tank gets just covered again.
Is this the imbalance in nutreances?

Salinity 1.25
Temp 77
Alk 8.4
Cal 430
Mag 1340
No3 2
Po4 0.03

Is this normal? I had it last to.e also.
Any tips? Or exsperance?

Ultimately would love to be off it. But tank seems to run too rich in no3

Sent from my SM-G935W8 using Tapatalk
Reply With Quote
  #2  
Old 05-29-2018, 12:47 AM
albert_dao albert_dao is offline
Good Guy Albert
 
Join Date: Jun 2004
Location: Richmond
Posts: 3,035
albert_dao will become famous soon enough
Send a message via MSN to albert_dao
Default

That level of offset from NO3 and Po4 shouldn't cause your cyano. You have other contributing factors. got a pic of the tank and how it's set up?
__________________
This and that.
Reply With Quote
  #3  
Old 05-29-2018, 01:55 AM
takeastabatit22 takeastabatit22 is offline
Member
 
Join Date: May 2017
Location: Coquitlam
Posts: 88
takeastabatit22 is on a distinguished road
Default

Quote:
Originally Posted by albert_dao View Post
That level of offset from NO3 and Po4 shouldn't cause your cyano. You have other contributing factors. got a pic of the tank and how it's set up?
Last week no3 was over 50.

Sent from my SM-G935W8 using Tapatalk
Reply With Quote
  #4  
Old 05-29-2018, 01:57 AM
takeastabatit22 takeastabatit22 is offline
Member
 
Join Date: May 2017
Location: Coquitlam
Posts: 88
takeastabatit22 is on a distinguished road
Default

Quote:
Originally Posted by takeastabatit22 View Post
Last week no3 was over 50.

Sent from my SM-G935W8 using Tapatalk
I had none befor nopox just heavy coraline

Sent from my SM-G935W8 using Tapatalk
Reply With Quote
  #5  
Old 05-29-2018, 02:03 AM
DKoKoMan's Avatar
DKoKoMan DKoKoMan is offline
Member
 
Join Date: Dec 2016
Location: Edmonton
Posts: 1,250
DKoKoMan is on a distinguished road
Default

Could be the change in nitrates (being reduced quickly). My tank is about to it 2 months after the transfer, I used all new sand and added some cured LR. I’m currently dealing with cyano myself, it’s on the sandbed and on the rocks trying to cover corals :angry:

As far as NOPOx goes, I used it in my overstocked 150g and it was a beast in nitrate reduction. The only negative was bacteria clumps in my sump (looked like a yellow/brown slime). I would use a turkey baster and suck it out.
__________________
300g Basement Reef - April 2018
Reply With Quote
  #6  
Old 05-29-2018, 02:33 AM
rsisvixen's Avatar
rsisvixen rsisvixen is offline
Member
 
Join Date: Sep 2014
Location: Maple Ridge/BC
Posts: 244
rsisvixen is on a distinguished road
Default

I have used nopox to get rid of cyno, it worked well for me.
Could be your flow isn't strong enough in those areas, cyno likes low flow areas.
Reply With Quote
  #7  
Old 05-29-2018, 06:24 PM
albert_dao albert_dao is offline
Good Guy Albert
 
Join Date: Jun 2004
Location: Richmond
Posts: 3,035
albert_dao will become famous soon enough
Send a message via MSN to albert_dao
Default

Yah, if I were to venture a guess, I'd first tackle the flow. Looks like you have a pair of Apex pumps in there, which would normally be sufficient, but your rockwork is really dense. A couple smaller pumps (Sicce Xtreams, etc) behind the rock would do wonders. That or you could just open up the rockwork.

Also, how is your sump set up? Are there any large piles of detritus?

Nice Candy Basslet btw!
__________________
This and that.
Reply With Quote
  #8  
Old 05-30-2018, 03:40 AM
Myka's Avatar
Myka Myka is offline
Moderator
 
Join Date: Mar 2004
Location: Saskatoon, SK.
Posts: 11,268
Myka will become famous soon enough
Default

If you use biopellets and plumb the reactor outlet to the skimmer inlet you will get much less cyano problem. Dosing products into the water column (liquid carbon dosing) I see a lot more cyano.
__________________
~ Mindy

SPS fanatic.

Reply With Quote
  #9  
Old 05-30-2018, 02:44 PM
takeastabatit22 takeastabatit22 is offline
Member
 
Join Date: May 2017
Location: Coquitlam
Posts: 88
takeastabatit22 is on a distinguished road
Default

Quote:
Originally Posted by albert_dao View Post
Yah, if I were to venture a guess, I'd first tackle the flow. Looks like you have a pair of Apex pumps in there, which would normally be sufficient, but your rockwork is really dense. A couple smaller pumps (Sicce Xtreams, etc) behind the rock would do wonders. That or you could just open up the rockwork.

Also, how is your sump set up? Are there any large piles of detritus?

Nice Candy Basslet btw!
Nice suggestion. I'll try somthing behind rock.
Sump is good. I'll get some build up on the rock but carbon ushualy cleans it up.
I get a build up of carbon and gfo from the reactors which I don't like.
In the sump I've got 30lbs live rock 2 LF reactors a baby pawerhead 6 mangroves a reef octopus and filter sock which I change daily.

Sent from my SM-G935W8 using Tapatalk
Reply With Quote
  #10  
Old 05-30-2018, 02:46 PM
takeastabatit22 takeastabatit22 is offline
Member
 
Join Date: May 2017
Location: Coquitlam
Posts: 88
takeastabatit22 is on a distinguished road
Default

Quote:
Originally Posted by Myka View Post
If you use biopellets and plumb the reactor outlet to the skimmer inlet you will get much less cyano problem. Dosing products into the water column (liquid carbon dosing) I see a lot more cyano.
I like that idea. But have never used them.

Sent from my SM-G935W8 using Tapatalk
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 01:24 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.