|
|
|
#1
04-26-2016, 04:26 PM
|
|||||
|
|||||
Magnesium and ratios ... 5:3 vs 8.5:1
Ok, so I understand that you normally want to dose Magnesium at 5:3 for MgCl / Mag sulfate, or 8.5:1 if you run a calcium reactor.
I recently started using a reactor again so it makes sense to me that to dose Mg into my tank that I want to use the 8.5:1 ratio. However what about the make up water for water changes? I usually like to top up this water for Mg (I use IO and Mg is a bit low for my liking). Should this not stay at 5:3? Thoughts?
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! Last edited by Delphinus; 04-27-2016 at 08:26 PM. 
|
Linear Mode
