#1
|
||||
|
||||
Tube cutting jig
Just a pic for ideas in DIY acrylic tube cutting jigs.
-the plywood sacrificial jig is double T-slotted for length setting -square jig end for squaring up tube that wasn't previously cut straight and square -adjustable back support for cutting different dia tube -sloppy cutting wood burn for beauty effect |
#2
|
|||||
|
|||||
Quote:
Steve
__________________
*everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one* Some strive to be perfect.... I just strive. |
#3
|
||||
|
||||
I think you are right about increasing the size of the end plate. So far I have only tried 6" tube. It's kind of nice to have no more fear cutting tube. One can even cut with one hand.
The miter slide is very accurate and adjustable. No wiggling in the table slot. Found it at LeeValley. |
#4
|
|||||
|
|||||
Good job Kari! Thanks for sharing the pics of the jig.
Nice tablesaw btw.. |