Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Product Review and Equipment Forum > Controller and Monitoring Specific

Reply
 
Thread Tools Display Modes
  #1  
Old 06-27-2014, 02:06 PM
Leach29's Avatar
Leach29 Leach29 is offline
Member
 
Join Date: Feb 2012
Location: Chestermere
Posts: 50
Leach29 is on a distinguished road
Default Programming Jaebo wp 40- Ideas for Apex

Hi Everyone,

I am looking to see what other people have done in programming there Jaebo WP 40 to there Apex.

I have (2)-WP-40 plugged into my V1/V2 outlet.

Thanks a lot!
Reply With Quote
  #2  
Old 06-27-2014, 02:12 PM
Aquattro's Avatar
Aquattro Aquattro is offline
Just a guy..
 
Join Date: Aug 2001
Location: Victoria, BC
Posts: 18,053
Aquattro is a jewel in the roughAquattro is a jewel in the roughAquattro is a jewel in the roughAquattro is a jewel in the rough
Default

Here's a simple little setup I copied from someone for my Tunzes. Would work the same for the WP40s. I'll probably do this for the new tank

=============================================

Wave1 (This is my main daylight wave pattern)

Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 7
Off time (Seconds) 4
Minimum intensity 0
Maximum intensity 100

Wave2 (Similar pattern to the above but Syn is disabled which creates a bit more chaos)

Synchronize Disabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 7
Off time (Seconds) 4
Minimum intensity 0
Maximum intensity 100

Lt_Flush (This is for the left side 6205 flush)

Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 0
On time (Seconds) 30
Off time (Seconds) 30
Minimum intensity 0
Maximum intensity 90


Rt_Flush (Rt 6205 alternate interval of LT_Flush alternates one on while the other is off)

Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 30
On time (Seconds) 30
Off time (Seconds) 30
Minimum intensity 0
Maximum intensity 90

DuskDawn (This is a lower flow wave pattern used intermittantly during the light hours as well as before and after lights go out)
Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 7
Off time (Seconds) 4
Minimum intensity 0
Maximum intensity 30

Night (Sets a constant 30% flow during light off hours)
Synchronize Disabled
Divide by 10 Disabled
Initial off time (Seconds) 0
On time (Seconds) 10
Off time (Seconds) 15
Minimum intensity 30
Maximum intensity 30

I am up to 3 timers. My use for the timers is to create short random periods of different flow during daylight hours. This is one area where I cant help but think there may be an easier approach. I could use some feedback here.

Timer1 (turns on every 120 minutes for 10 minutes. If timer 2 is on at that time, it should remain off.

OSC 120:00/010:00/000:00 Then ON
If Outlet Timer2 = ON Then OFF
If Time 19:30 to 11:30 Then OFF
If FeedA 000 Then OFF

Timer2 (turns on every 45 minutes for 15 minutes except if timer 3 is on)
OSC 045:00/015:00/000:00 Then ON
If Outlet Timer3 = ON Then OFF
If Time 19:30 to 11:30 Then OFF
If FeedA 000 Then OFF

Timer3 (turn on every 15 minutes for 5 minutes except if timer 1 is on)
OSC 015:00/005:00/000:00 Then ON
If Outlet Timer1 = ON Then OFF
If Time 19:30 to 11:30 Then OFF
If FeedA 000 Then OFF


-----------------------------------------------

These are the variable speed pumps and their programming:
StreamLt
Set Wave1
If Time 10:30 to 11:59 Then duskdawn
If Time 12:00 to 19:00 Then Wave1
If Time 19:01 to 20:00 Then duskdawn
If Time 20:01 to 10:29 Then Night
If Outlet Timer1 = ON Then Lt_Flush
If Outlet Timer2 = ON Then duskdawn
If Outlet Timer3 = ON Then Wave2
If FeedA 000 Then OFF


StreamRt
Set Wave1
If Time 10:30 to 11:59 Then duskdawn
If Time 12:00 to 19:00 Then Wave1
If Time 19:01 to 20:00 Then duskdawn
If Time 20:01 to 10:29 Then Night
If Outlet Timer1 = ON Then Rt_Flush
If Outlet Timer2 = ON Then duskdawn
If Outlet Timer3 = ON Then Wave2
If FeedA 000 Then OFF
==========================================
__________________
Brad
Reply With Quote
  #3  
Old 06-27-2014, 04:39 PM
Leach29's Avatar
Leach29 Leach29 is offline
Member
 
Join Date: Feb 2012
Location: Chestermere
Posts: 50
Leach29 is on a distinguished road
Default

Awesome thank you.

I will try it out tonight.
Reply With Quote
Reply

Tags
apex, jaebo

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 11:30 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.