#1
|
||||
|
||||
Acrylic rods for aquascaping
I see a lot of people using these for their aquascaping, think i'd like to give it a try myself... Does anyone know where to pick these up in town? any idea on the cost? Thanks!
__________________
Sean |
#2
|
|||||
|
|||||
Sean alot of people are using 1/2" PVC
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#3
|
|||||
|
|||||
I get all my acrylic supplies from IPP, there is one in Calgary, check them out.
Industrial Plastics & Paints (403) 252-8368 5558 1 St SE Calgary, AB T2H2W9 |
#4
|
|||||
|
|||||
I got mine from IPP in calgary, and have a couple of complete rods left over if you'd like to grab them. One rod is 1/2" one is 5/8 inch. Both are 6' in length.
|
#5
|
||||
|
||||
Thanks for the offer, I'll have to do some planning and see what I need. didn't think to use 1/2" pvc.
__________________
Sean |
#6
|
|||||
|
|||||
I've got some 1/2" pvc leftover you can have. Couple 4 foot lengths. It's so cheap to buy it might not be worth it but it's yours if you want. I think the pvc is a lot less flexible. May or may not be good for what you want to do.
|