|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
#1
10-15-2004, 01:59 AM
|
|||||
|
|||||
Second chamber PH?
What should the Ph be when coming out of the second chamber? My second chamber is just a run through so that the media can mix with any remaining Co2, and also to help elevate PH. So I can't figure out if the first chamber which is mixing with the CO2 is at a low enough PH.
|
|
#2
10-15-2004, 05:02 AM
|
|||||
|
|||||
|
The pH in my second chamber is not significantly different than the first. The difference is like 0.01. (I run the first chamber at a target of 6.7). I don't know if that means I'm running the effluent too quickly (60ml/min) but anything less than that and the levels start to drop, so, I don't have much wiggle room.
I would take a few measurements of the pH in the first chamber (disconnect the second chamber temporarily). Then at least you know what's happening in there without guessing from the second chamber's pH.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#3
10-15-2004, 08:46 PM
|
|||||
|
|||||
|
isn't the second chamber suppose to be 7.0
to equal out what the rector puts out . mike
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
