Drilling a nano
I've been turned down by big al's to have my 6 gal drilled. What's the chances it will break during the drilling? Do they drill a circular hole in the bottom of the tank, or cut squares out of the back glass plate for an overflow box?
Thanks for any help!
TANK BUILD EQUIPMENT SO FAR:
70w DIY MH (gotta figure out what kind of bulb is in there)
Coralife 12" CFO w/actinic striplight
AC 50
Eshopps hob nano overflow
Hydor submersible heater
2 5w comp fans installed into tank box
8gal aga
Last edited by dmagrath; 02-16-2011 at 03:47 AM.
Reason: Want to change the thread to a build thread
|