View Single Post
  #2  
Old 12-03-2010, 12:47 AM
martinmcnally martinmcnally is offline
Member
 
Join Date: Jul 2008
Location: Red Deer
Posts: 599
martinmcnally is on a distinguished road
Default

Sounds good. I tried building an LED bar to supplement my T5s unfortunately I failed miserably. I found it really really hard to solder wire onto the CREE LED points. The solder would not stick properly unless I scratched the little metal solder point on the LED, then it kind of worked but would also easily break off with a little nudge. I might try another experiment but maybe I am missing something with the soldering. I was thinking maybe you needed to drill a whole in the solder point and feed the wire though it like you would see on a circuit board with components soldered on.

Martin
Reply With Quote