sorry I didn't want to start another thread so since it was related figured id post here:
in terms of dosing would this be the correct procedure?
1. once calibrated, test params and use reef calculator to figure out how much is needed to reach desired levels
2. set dosing amounts
3. after monthly water change, re-test and reset dosing amounts based on new params
4. repeat step 3 after every water change?
not sure if I have a bad batch or not, but I noticed my aq reef salt produces a low ca. i am going to open another box, although I bet they will be part of same batch. Also considering H2Ocean since it has higher CA levels.
|