[NastayNatron]

It's wet!



Time to finally get my rocks up into the tank! While researching aquascaping ideas, I came across one photo that I thought would fit my tank perfectly. I couldn't get the image out of my head so I decided to try and mimic it as best I could.

Inspiration:



Off to work! I used a hammer drill bit in a standard cordless drill to create holes where I needed them in the rock. Following that I inserted 3/8" acrylic rod into the holes. Some of the rock was epoxied, but a large amount was not. This way, if needed, I can easily lift a rock out of the tank off the acrylic rod.