Quote:
Originally Posted by Milad
It needs 12v. Most people have a 12v around the house. We also gave the flexibility to them to use different current for different setups. So if you are just doing drivers, you need a very low current power supply (500mA). If you are doing LEDs directly then you can get a 5A power supply.
I also got the update on the new LEDs. Prototypes are in route to Vancouver as we speak. I should have them early next week if not tomorrow. I have a PAR meter in route also. Im going to run some numbers comparing a CREE Setup vs the new LEDs (i might do some 150w MH just to get an idea.
If everything looks good they will go into production and I should be getting them sooner than later.
|
HiYa Milad
Its been a while between updates on this and I was curious to see your advancements and progress to date.
Any chance you could share were your at please.
Thanks
