Well...
Today was a slow day at work, which led me think a bit.
How can I make things simple and avoid a ton of redundant parts without tying up the PWM outputs of the Due
Long story short...
Here's the answer !!!
TI's
LM3463 !!
Some of the Key Features that are of interest to us:
- Wide supply voltage range 12V - 95V
- 6 driven channels ( using MOSFET's
- Capable of Analog, PWM dimming OR Serial Control
Right now the only thing I'm debating is the output stage.
In order to keep the board size down I would have to go to a TO220 through hole transistor over the DPAK surface mount units. This way a heat sink can be used rather than using precious board space as a heat sink.
With that being said...
Light Control Module ( LCM ) specs I have in mind are as follows:
- 12V - 48VDC Input
- 6 Channels
- High Current Capable
- Full Control ( Analog, PWM or Serial )