View Single Post
  #5  
Old 12-03-2010, 01:00 AM
DiverDude's Avatar
DiverDude DiverDude is offline
Member
 
Join Date: Feb 2010
Location: Calgary
Posts: 519
DiverDude is on a distinguished road
Default

Using a flux-core solder should be fine unless the LEDs are old and/or been improperly stored -in which case the copper pads may be oxidized.

Most soldering difficulties come from improper technique. It's important to remember that you are joining TWO metal surfaces with a 3rd metal (solder) and therefore BOTH surfaces must be hot enough to melt solder. A decent soldering iron is also good to have. A reasonable iron will cost a good $50 at Active. Good brands include Hakko and Weller.

-And try not to breathe the fumes from the solder; NOT good for you.
__________________
-Mark

29 Gal Bowfront w/24" LED Lights. DIY HOB Sump (5.4 Gal) MP40. Orange Spotted Watchman Goby, 2 Clownfish and a few hermits.
Reply With Quote