View Single Post
Old 12-02-2010, 11:47 PM
martinmcnally martinmcnally is offline
Join Date: Jul 2008
Location: Red Deer
Posts: 600
martinmcnally is on a distinguished road

Sounds good. I tried building an LED bar to supplement my T5s unfortunately I failed miserably. I found it really really hard to solder wire onto the CREE LED points. The solder would not stick properly unless I scratched the little metal solder point on the LED, then it kind of worked but would also easily break off with a little nudge. I might try another experiment but maybe I am missing something with the soldering. I was thinking maybe you needed to drill a whole in the solder point and feed the wire though it like you would see on a circuit board with components soldered on.

Reply With Quote