[shiftline]

Oh perfect! That makes my life easier. For a feed pump I was going to make a manifold off a seperste DC pun for some reactors. Wold tapping off that cause any issues or do the trick for a feed pump. In Theory it can only take in what it drips out to make space for

Now I need to find a PM1 module to run an extra probe.

Does it matter if the unit sits inside the sump? Likely depends on the pump Not sure if it will fit otherwise as of yet. So it looks like I need a 1/2" tap for that fitting?

The pump is also a little loud. Would a Jabeo DC pump work well for this?