Quote:
Originally Posted by dcw1sfu
Received my bucket of Aquaforest reef salt today. Should be receiving the rest of the products in the next week or two as well as Siporax.
Did a small 5 gallon water change to test parameters and overall I was impressed. It mixed clean and clear in a matter of minutes and all parameters were very close to the ones on the quality control sheet. Overall seems like a high quality salt and perfect for carbon dosing. Obviously to early to tell if it will have positive effects on my tank.
Parameters at 1.026 salinity all tested with Salifert
Calcium 415
Magnesium 1320
Alk 7.4dkh
Potassium 400
|
Did you blend the salt before mixing? I have the same batch number and I'm getting the following readings at 35ppt:
Ca 420
Mg 1410 (new kit)
kH 6.7 (tested against the standard solution)
K 360
I may have purchased an old (but not expired) potassium test kit and it seems it could be reading low. This could be a problem since I've been dosing K to try to bring the level up to 400.
I've always thought that stratification was a myth, but perhaps not. I'm going to blend the salt before my next water change and see what happens.