I had some left over ditra from a shower reno that I decided to use. I figure this would help keep moisture in without damaging the drywall on the outside of the base.
I also ran a drain line to the basement, the drain line is split here, top one will be attached to the tank and the bottom is a just in case water leaks from the bulkheads or reservoir tank. Also added 2 fans to keep air moving.
Doing some patching just so it looks clean
I also ran 2 separate water lines that would pump rodi and mixed saltwater.
Attached the 14/2 wire and ran a network cable for the Apex. I decided to cover the base with a waterproof fabic, a lot of this is overkill but I couldn’t risk having water in the bonus room. Basically if water overflows from the sump, under the DT bulkheads or the RODI reservoir it will flow into the bottom drain without damaging the floor.
