Quote:
Originally Posted by Doug
That worked for turning off the ORP probe. Now to get it to work on the Energy Bar
And what kind of stupid thing has to be hard wire instead of wifi to do an update. ?????????????????????
|
Wifi can be unreliable and interrupt the firmware install, which can really screw your Apex.
I remember having a similar issue as you. I am trying to think of what exactly caused it . My skimmer outlet would always go on and off. Pretty sure I had to unplug the "usb" connectors to everything, then plug each one in after the apex recognized each one. I have had to do this a few times , for various reasons and it always worked. I left the base units power on. but unplugged everything else, then plugged each units power in, then plugged in the "USB". Apex support ran me thru it, as it was their suggestion.
Have you looked at the "module setup" in the apex controller, under the configuration tab? It should give some insight as to whether it is "OK"
I think another time, I programmed an outlet to shut another one down "IF" something happened. I forgot I had programmed that in. so I read thru each outlets programming...
Found the support ticket from Apex
The results here indicate something is shorting out your aquabus. It could be the transceiver in the base unit is blown or one of the modules is shorting it out.
To determine if is is a device/cable shorting out the bus:
Remove all aquabus devices from the base unit (including the display screen).
Now reconnect only your Energy Bar to the base unit. Does the base unit and Energy Bar produce a solid green status light?
If not, then try another cable with that EB8
If not, then try another EB8 and continue to swap cables.
Let me know how it goes.
Please let us know if you have any other questions, or need any additional clarification.
Please Reference Ticket:
http://neptunesystems.freshdesk.com/.../tickets/30532
Thank you,
Neptune Systems Support Team
-------------------------------------
Paul Jansen
Neptune Systems Support
T: 408-779-4090