View Single Post
  #3  
Old 09-06-2014, 04:53 AM
gregzz4's Avatar
gregzz4 gregzz4 is offline
On Hiatus
 
Join Date: Oct 2011
Location: Burnaby, B.C.
Posts: 4,890
gregzz4 will become famous soon enough
Default

The lines in your system may need to be trimmed back due to compression leaks if you've messed with them.
They should not leak for a long time, but could be due to fitting seating issues, or if you've messed with them a bunch of times
Re-seat all your lines and all should be good - remove a line from a fitting and trim the end off - then reseat the line by pushing it fully into the fitting
It's always a good idea to use some kind of lube and make sure the ends of the tubes are not sharp so they don't damage the o-rings inside the fittings

So, If you have enough slack in your lines, remove them from the fittings and trim them back a tiny bit. When you do so, make sure they have no sharp edges before you re-insert them into the fittings

I use locks to keep my lines from backing out

Reply With Quote