help with profilx diy led
Im trying to hook up my diy led lights to my profilux controller with an EVG-AP-2F. I got it all wired up but it wont dim. It will either turn on or off and when its on the intensity is probably at 30% but on my controller its saying it 100%
my drivers are dimmable maxwellen. I was using a potentiometer to adjust the intensity before.
Also not sure if it matter but when i check the voltage coming out of the dimming part of the EVG-AP-2F it reads 20 volts but if i wire the dimming wires directly to each other without using the EVG-AP-2F i get 100% intensity on my lights which leads me to believe the the EVG-AP-2F is wired properly, but something isnt letting me do what i need.
|