So I bought new PCB boards with the drop down resistor to prevent the LED's from going full 100% if the board looses the pwm signal. Thanks to Scubasteve for that modification! I'm sure this will save many a coral from being baked.
But, that also means I have to de-solder all my old boards and resolder everything on the new ones... wheeeeeee!
Here's the new baord and the start of soldering the drop down resistor:
And if anyone doubts the teeny tinniness of these resistors:
All the resistors in on one board and the dip sockets:
And with the terminals and jumper pins soldered in:
