Quote:
Originally Posted by lockrookie
Can you in thread it a bit add more Teflon to it more on the heavy side near the end and re seal it quick? I had that happen to me as well
|
Well my sump is currently full of water...so no, not right yet. The leak is even slower than I thought, after the entire night, there was a little more than a thimble full of water in the cup underneath.
If you wondering why my sump is full, its because I'm prepping to push water up to the display. I'm currently making another 100g of fresh water and I'm mixing 100g of salt water and sump holds about 60G of saltwater (not including fuge). My plan is to fire up my water change station at the same time as my return and try to push about 140g upstairs to the display. I need some more hands as my return nozzles will destroy my aquascape unless someone is deflecting the flow. I also haven't checked my plumbing from the pump up to the display (most of it was done by plumber in wall) so I will want an extra pair of eyes to look that over at the same time too.
Can't believe that this is finally getting close. I have so much more work to do on this...my APEX isn't setup, my dosing isn't set up, my skimmer isn't set up...but water is a major step.
