Wow, it's been almost 3 weeks since my last post. Time is flyin' by.
I've plumbed the Return and Chiller/UV/Chaeto pumps a couple of times.
I'm happy with the return, but the other is about to change again, so no pics.
And I've also decided to make a sump design change.
With the sock hanger after the bubble trap, it's counter-productive. It's noisy and creates bubbles.
I'm moving the Heaters to the right, and putting the Sock hanger in their place, with the Reactors hanging inside the sump in front of the Skimmer.
The overflow will go through the Skimmer chamber, down through the Socks, then up and over the Heaters as it exits the bubble trap.
I'm mostly happy with the other pump circuit, but need to re-route the Reactor circuit, so pics later.
I tried cutting the silicone out, even with a guitar string, but no go. I ordered the original glass snug enough that I couldn't get a blade through.
I ended up taping the glass, scoring it, and smacking it. It took a freakishly hard blow to break it.
Tomorrow I pick up the new glass.
I'll post a pic next week once I'm happy with the setup.
While the silicone is curing, I'm going to finally tackle the wiring.
I picked up a new Reefkeeper Elite last week and can now start all that planning etc.
If you missed it, and because I can't edit the original post ...
I originally bought a Reefkeeper Lite, but will use it on the QT as I now want more modules on the DT than I had originally planned on.