Thanks Myka. From what I have been reading the opinions are foam under tanks without a trim and no foam under tanks with a trim. The trim I described in my first post is not the "normal" trim that I have seen on other tanks. The bottom pane of glass would almost be resting on plywood if I used it. So would this be considered trimless? Tanks only need to be supported on the outer edge correct? I'm thinking if I use the styrofoam without the plywood it would even out any imperfections in the 2 X 6 while not putting upward pressure on the other sections of the bottom glass. Anyone see anything wrong with this? From what I can tell the sides of the tank are sitting on the bottom glass. Thoughts?
|