The plan for the doors is pretty simple. Hopefully it works out.
I have a third curved piece that I milled identical to the top and bottom curve rails. I plan to mark the centre of the rail and cut it in half. This will then form the inside brace for the door. I'll then use milled 1 x 3 s to form the actual doors.
Basically, I am copying the design of the AGA stand. The back pannels will be removable and will have exhause fans monted in them. Teh top panel I am thinking of making aluminum and vented for heat disipation.
The other idea I had was to build a dual plastic screen top so hot air could easily escape but the light would be diffused through two layers of screen.
Obviously I've still got some work to do!
|