Some pictures of the fixture, note not all LEDs are on and I used a fill flash so you could actually see the fixture, it's as bright if not brighter than your typical LED fixture. This fixture can use a max of 350W, this is lots for LEDs.
The fans pull in air from below, push it through the heat sink then out the top. The LEDs and drivers are 100% protected from the water with a tightly sealed cell cast acrylic shield (will never warp).
LEDs are riveted on so they can be replaced if ever needed.
Can be dimmed manually or with PWM control, adapters available for 0-10V dimming as well.
I will also throw in a soldering iron and any advice or guidance needed to adapt this fixture to anyone's needs.