I've seen quite a few mods done for lighting the fluval edge. Some people swap out the MR11 endcaps for MR16's and put in 2 MR16 multi-led spotlights in place of the stock halogens.
Others I've seen put a ~5x6" heatsink with 6 - 9 LED pucks on it driven by a buck puck or meanwell driver. This is what I'm planning on doing with my fluval edge as the lightspread seems to be a bit better than with just 2 LED spotlights, however it's the more expensive route to take.
I'd be a bit hesitant to drill this tank though. The glass is so thin that I'd be worried about shattering a pane. Since the tank is so small though, I'm guessing you could do it with a drill press as opposed to a hand drill which would greatly reduce the chance of cracking/chipping the glass as it was being drilled.
__________________
Do or do not....there is no try.
|