Quote:
Originally Posted by martinmcnally
Sounds good. I tried building an LED bar to supplement my T5s unfortunately I failed miserably. I found it really really hard to solder wire onto the CREE LED points. The solder would not stick properly unless I scratched the little metal solder point on the LED, then it kind of worked but would also easily break off with a little nudge. I might try another experiment but maybe I am missing something with the soldering. I was thinking maybe you needed to drill a whole in the solder point and feed the wire though it like you would see on a circuit board with components soldered on.
Martin
|
i haven't soldered for years but if i remember correctly its like an art.
just takes a few tries soldering a few together
also did you have pretinned wire? you dont want to heat up the led solder too much otherwise boom goes the led.