[Stones]

Thanks for the compliments everyone. Luckily I was able to get the tank salted before I got called back out to work. I couldn't believe it took nearly 2 full pails of reef crystals to get the tank up to 1.025!

Also got my substrate put in the tank but I didn't have time to snap any pics. I ended up going with Caribsea Seaflor Special Reef Sand. I had sugar sand in the previous setup before moving and I always had bare glass showing on the bottom of the tank due to my vortechs. I really wanted to avoid this but I didn't want to go bare bottom either. I'm hoping this substrate is large enough that it won't get blown around. So far its been behaving but the vortechs are still in the 90 gallon so all the flow is coming from two 3/4" eductors run off my mag 18 return pump.

I really like the look of schedule 80 pipe as well. I tried getting most of what I needed for the plumbing off of BRS but plans changed and I ended up having to get about 2/3 of the fittings and all of the pipe from a local pump warehouse. I'm sure I ended up spending over $300 on the pipe and fittings whereas I could have probably done the whole thing in schedule 40 for under $100. Since nothing has prices on it there, you get a nice surprise when its time to pay. After seeing my invoice, I remember that the 2" sched 80 "T" fitting was $22 and I ended up needing 2 of them.......brutal.

I also got the last 2 holes drilled in my eurobrace so I now have a 1" uniseal in each of the 4 corners. If (more likely when) I get a new tank built, I'm definately going to leave drilling the holes to the experts.

The first 2 holes I used duct tape on the bottom side of the eurobrace to hold the glass in place so that the glass disc wouldn't fall into the tank when the bit finally cut all the way through. On both of these holes, I ended up with significant chipping when the drill bit punched through the final bit of glass even though I was taking my time and making sure to keep as much weight off the drill bit as possible.

So on the last 2 holes, I decided to brace the bottom of glass with a piece of 3/8" acrylic that I clamped to the eurobrace instead of using the duct tape. My thinking was that if the glass was braced from the bottom, when the drill bit would cut through the bottom of the eurobrace, I wouldn't get any chipping seeing as the acrylic would be pushing up against the glass. In theory, everything sounds good. But in reality, I ended up with the same amount of chipping as I did using the duct tape. Its is still pretty minor as most of the chips are only ~1/16" or less in thickness but it is still angering to say the least. With the uniseals installed and after I get the trim put back on the top of the tank, the chipping won't be visible and I'm not worried about the structural integrity of the eurobrace as there was no cracking.