Quote:
Originally Posted by fencer
1st guage tank pressure
2nd guage supply pressure
then the soleniod
then it looks like the needle valve.....for gas input to the reactor
there should be a clamp of sorts on the in flow line from aquarium to the reactor...this regulates water input
|
thanks. right now the tank pressure is just over 5 MPa which would be 750psi if i'm right. its a 10 pound tank. 1 MPa = 150psi, the other gauge i had about 0.1 which is 15psi. so i just need to adjust the needle valve then. think i have it figured out