Fudge,
I REALLY like the reactor now that it is hooked up. Very good workmanship as well.
The way this works is that the reactor is kept at a constant pressure of 2 to 5 PSI and is basically dripped down the media which appears to be a shaved plastic of some sort. Could be PVC for sure. Here is a closeup. You can see the Ozone being injected into the top chamber where all the bubbles are.
What happens is the water starts to run into the container and the Ozone is pumped in until it reaches about 5 PSI, then the water is flushed out and through a chamber (the larger on on the far left of the pics in my previous post) that holds carbon and back into the tank. The air then gets jetted out into the Carbon Air filter (The thin one in the middle of the pictures in my previous post). I am sure you know this but you have to run the air through carbon to remove the ozone from getting into our breathing air
Not only does the pressure increase the efficency of the Ozone but the contact time is MUCH longer than a standard skimmer.
I was listening to an article on Talking Reef about contact time of ozone to be REALLY effective and they said it needed to be much longer that what a standard skimmer gives you. This reactor solves the problem.
2 thumbs up
Quote:
|
Originally Posted by Fudge
Very Nice Andrew.
I am interested in using an ozone reactor myself, Ozone is hittin my skimmer pretty hard.
A few Questions for you,
What is the Media in the reactor ? Looks like vinyl or pvc chips of some sort.
Is the carbon chamber for the air intake to the ozonizer ? or is it to feed product water after the main reactor..removing residual ozone ?
I seen the other chambers you said the were for return water and return air, could you elaborate a little for me?
What is the third chamber you have there for ?
Thanks, Marc.
|