Canreef Aquatics Bulletin Board

		Canreef Aquatics Bulletin Board > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: gregzz4

Forum: DIY

07-06-2018, 10:52 PM

Replies: 8

C2C weir cut

Views: 2,176

Posted By gregzz4

One other thing. Do some research about the weir...

One other thing. Do some research about the weir height. With a C2C the water flowing over will be very thin so you won't need to cut very low. I'm thinking 1/2" will give you lots of wiggle room as...

Forum: DIY

07-06-2018, 07:44 PM

Replies: 8

C2C weir cut

Views: 2,176

Posted By gregzz4

Look online. I remember seeing a site that showed...

Look online. I remember seeing a site that showed how far from the edges to drill. It discusses glass thickness and hole sizes. Remember that you want your overflow box to be 3 or 4 inches deeper...

Forum: DIY

07-06-2018, 07:31 PM

Replies: 8

C2C weir cut

Views: 2,176

Posted By gregzz4

I suppose you could do that as the ends of your...

I suppose you could do that as the ends of your box will be the fill in pieces. But if you do your box will only be 2 inches deep. Not sure how well it would drain without making a lot of noise.
...

Forum: DIY

07-06-2018, 03:02 PM

Replies: 8

C2C weir cut

Views: 2,176

Posted By gregzz4

Usually, the front and back panes support the...

Usually, the front and back panes support the side/end panes. With that in mind you'd have a gap between the overflow box and the sides.

Forum: DIY

07-06-2018, 03:25 AM

Replies: 8

C2C weir cut

Views: 2,176

Posted By gregzz4

Not sure I understand your questions, but when...

Not sure I understand your questions, but when you cut the back glass, you need to drill holes at the ends at the bottom corners, then cut from the radius/outer edges of the holes to the top of the...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT. The time now is 05:41 AM.