3" bulkhead fittings, anyone know where to get one??
 

So I wont go too far into the details but little sleep led to some assuming going on and some skipping of verifying steps happend and now I have a 3 1/2" hole in the side of my sump. Crap. 2" bulkhead takes a 3" hole. So im after a 3" bulkhead and I will just bush it down. Im hoping I can find one as if I dont its $200 for a new sump tub. Anyone know where to find one??? I have a couple emails out to some of the canreef vendors but nothing as of yet. Thanks.

http://www.winnipegplastics.com/bulkhead-fittings
Not sure if they sell to the public but you could contact them?

If they don't have one, try here, online in usa

http://flexpvc.com/cart/agora.cgi?pr...ttingsStandard

I think you may get away with a 2 " cause it says up to 3 1/2 " hole

on whos bulkhead? The ones from JL say 3" hole. I might be forced to order from one of the usa sites but im trying to find something a little closer then 2 weeks away. Thanks.

Southern drip irrigation in Chilliwack

I think scd 80 2" uses a 31/2" mount hole

check with concept in calgary

slightly smaller than 3 1/2 but should do the trick!

If its just the sump can't you silicone on apiece of plexiglass over the hole let it dry then redrill it ?