Who uses a Wet/Dry Shop Vac on their Reef?
 

Just wondering who out there uses a wet/dry shop vac to clean out their sump? I seen people mention this, but want to know how effective they are. Can they overflow and make a mess, or do they switch off when full of water?

Thinking of getting one to easily clean the bottom of my sump, as trying to create a syphon with a gravel cleaner doesn't work well due to lack of height.

Thanks for any input.

I have been for a while now, first I remove as much water as possible via other means, then out comes the vac and crevice tool. My vac has a big float/ball valve that closes when it gets full (shopvac brand)...very effective and easy to do during a WC, IMHO

following along...

I'll probably use my shop vac for tank stuff when I finish using it for all the construction (kind of a pain to switch between wet and drywall bags). Mine has a hose attachment so you can actually pump the water directly to a drain as appose to just filling it up.

All shop vacs should have a shut off, they won't typically turn off but when full a float of some sort will cut off the suction.

I do, mine has a ball that when its full it shuts off the suction.

I do oone time when my floor got flooded. Hehehe

The thought makes me nervous as salt water is very conductive, little bit of mist in the vac and whammo you have an afro. Freshwater is not very conductive so I would do it then. I would first make an extension cord with a GFCI and plug the vac into it.

I use an old salt bucket, I cut 3 holes in the lid, 1 for the shop vac hose, 1 for a 3/4" hose I use for vacuuming and a 1" hole to let some air in so the bucket doesn't collapse and it slows down the suction so I don't suck the water out too quickly which gives me more time to get the gunk. Saves getting the smelly gunk into the shop vac.

That's actually quite genius :idea:

Although I think I'd skip the third hole, seems to me unlikely a shop vac could collapse a standard pail but perhaps a valve for some adjustment would be wise... hmmm

If using a shop vac rinse out the bucket and let it dry after use. I had a bout of small leaks and let the cruddy salt water sit for a while before I emptied it out. A few Weeks later I go to use the vac and the motor would not fire. Assuming corriosion from the salt. I was going to hack it apart to look at but after getting a replacement on sale cheap it got turfed. It was fairly new and should not have burnt out yet I have punnished shop vacs pretty hard at work.