Led help!!! setup
 

I followed instructions from aquastyle online.

http://img.tapatalk.com/d/14/05/10/pytuny3e.jpg

Cleared my connections and checking all wires. Everything is fine.

http://img.tapatalk.com/d/14/05/10/2a7e5edy.jpg

I have two of these.

I did all the wirings right but when I plug it in. Its very faint....almost like no power to it.

http://img.tapatalk.com/d/14/05/10/6etemu4e.jpg

It is not bright at all, but when I do unplug and its powering down it shines bright quick and then turns off.


Please I need help led gurus.

Its a bit brighter when I do four led only.

Make sure you don't use less than 8 LED for that specific driver and are you sure all LEDs you have run at a 1.3amps if not you will burn some of the LEDs.
I suppose you are not running a potentiometer?
Make sure you have a clean soldering job on those LEDs as you don't want to kill the current.

I did what you told me.

It flashed again and not bright when plugged in.

http://img.tapatalk.com/d/14/05/10/rezapeva.jpg

When I plugged it. http://img.tapatalk.com/d/14/05/10/u5utu8a8.jpg

It gets discharged after I plugged it.


http://img.tapatalk.com/d/14/05/10/aba7ejuh.jpg

Thats the last flash it does... then goes off. :(

Im curious what the blue and white wire does? Do I need a dimmer?

http://img.tapatalk.com/d/14/05/10/u6unevun.jpg

Are those LEDs rated to run at 1.3Amps? Looking at it from your photo doesn't seem so especially the red one.
Do you have the rating for those LEDs
double check the soldering job as to not cross wiring and no loose solder around them.
never worked with the meanwell drivers as to weather you require a potentiometer or not to run properly.

Zooming in on your solder job and from what I see your wiring is touching the edge of the star as it shouldn't and that's loosing and crossing the power leads to killing the LEDs.
Solder job should be clean and no burnt as dark spots witch restrict current flow.

I just found my own answer.

Lol

I do need a dimmer... thanks google!


Without a dimmer its at 0% brightness. I tested running a 9v in the blue and white wire then bam lights up.

Thanks eli as well!

Glad to hear you resolved the issue