Acceptable Humidity Levels
 

What would be an accept table humidity level in the house? I have a total of 460 gallons in the basement with a humidity level hovering around 75 – 80 %. With the recent addition of a 265 my wife noticed the increase humidity in the behavior of her hair ( I laughed at first ) The 265 is no where near ready to run, I have it full for a leak check. The plan was to add an exhaust fan to vent to the outside above the tank. How much could I expect the fan to lower the humidity?

I believe between 50-60% is normal

J

The fan should help, but then you're relying on the doorjambs and windows and furnace intake to replace the air that is drawn out.

75%-80% humidity is going to end up being a real problem for you. When it starts to get cold outside you'll see what I mean - the outside walls and windows will get a heavy condensation form, especially at night, and this in turn causes things like mildew and mold. In the summer it's not so bad, in fact you may even get to like the humidity - but yeah ultimately 75% is way too much for our climate.

I know this because humidity has been a problem I've been battling for years with my tanks. In my old house, the outside walls were 2x4 and this wasn't adequate insulation against the temperature differentials. So I built a new house using post-2000 building code rules and guess what, now houses are so air-tight in their quest to be more energy-efficient, that it's the same problem all over again (just due to a different reason) - the house just doesn't have enough air turnover to shed the excessive humidity.

Anyhow, the fan should work. It's not the best solution for our climate but it will vent the wet air out, which is what you want.

The ultimate solution is to use a HRV ("Heat Recovery Ventilator") instead of an exhaust fan. The concept is basically the same (ie. venting air to the outside) but with two important details: 1) The air that is vented outside is replaced by air from the outside, thus removing the "air deficit" that a fan alone would create, and 2) It uses an heat exchanger to use the outgoing air to preheat the incoming air (which is important when it's -40 outside). They recover something like 85% of the heat of the outgoing air, which is good when it comes time to look at your monthly heating bills. :)

Anyhow hope this info helps. Definitely do a fan or something, 460 gallons evaporating into your house will have an adverse effect.

I have 350+ gallons in my house and never get above 55% or so. I am usually at around 40%.

You need an HRV or else be prepared to get mold. Then you may as well just burn the house down.:neutral:

What about dehumidifiers? I think I spelled that wrong but you know what I mean.

http://cgi.ebay.ca/Soleus-CFM40-Port...QQcmdZViewItem

HRV's are only an option to reducing heating costs by recovering some of the heat being exhausted. To elimate moisture issues you must "exchange air" simple as that.

If you are truly serious about not having any moisture issues, a make-up air system should be considered. This would include a small furnace with a stainless steel heat exchanger to draw 100% fresh air from the outside, there would also be an exhaust fan interlocked with the furnace. The cfm output of the furnace and exhaust fan should be close in performance. An HRV can then be used on this to recover some of the cost running this system when its -40.

For whatever reason, our house is at 75 humidity as well and we are having problems as listed above. As we only have a 3 gallon tank in our house, the issue has to be other things. We are looking into getting a dehumidifier to help with the issues. From our research so far, Home Depot seems to have some at reasonable prices with quality names.

I think i will share my experiences.

Last winter was the first winter for my 350 gallons in my Townhouse. The humidity is really a problem, Condensation at the windows (turns to Ice at the window sills), Fallin ceiling paint and damp clothes.... that was what happened when you have -20C outside and a humidex of 60.

I bought a De-humidifier and that helps out alot. but the bad thing is the electricity bill, without the dehumidifier the bill already reach$2XX... with it on the billi was about $45-50 dollars more/month.

i think about the exhaust fan idea, but i ask a couple friends that are in the HVAC trades about it and they all think it is dangerous, because if you have a low power fan, it will not do much. if you use a high-powered exhaust fan blowing humid air out, some air has to come back inside your house, it can either come from your freshair intake OR your furnace exhaust -- very dangerous CO poisoning, and your gas bill WILL go WAY UP due to cold air coming in.

so i was recommended by others to try a HRV - heat recovery ventilator.

this unit i bought don't cost much to setup and it will do a few things for me.

1. bring a constant supply of fresh air from outside while heat is retained.
2. build in HEPA filter helps me breath a little easier especially if you have other pets.
3. remove excess humidity.

these in turn will lower my energy bills, my doctors bill and keep your family member happier - another example would be like choosing between a air conditioner(your family memebr enjoys it TOO) or a aquarium chiller(only your fish can enjoy).

This will be my first winter with a HRV so i am not sure will it perform the way i want it to, but it certainly solve most problems encounter by me.

just a 2 cents.

I would like to hear how you make out with the HRV this winter. Last fall I installed a Humidex unit (http://humidex.ca/index.htm) to replace my dehumidfier as well as its operating cost. It is quite cheap and easy to install. Have any others tried it? The Humidex unit is a very simple concept, drawing cool and moist air from the floor and venting it to the outdoors. It is very quiet and kept my humidity level between 40 - 60 percent all winter and throughout the dog days of summer. It is fine, but as I continue to add tanks to my fleet...the humidity will become more intense. The next step may be an HRV.

I don't mean to pry, but how much do these "HRV"'s cost? And where can you buy them?