WP40E help...
 

Hey guys, i'm the new owner of a fancy wp40e and i've finally figured out how to roll through the modes and set a decent wave on short pulse mode. The device can save your pulse that you configure but I can't figure out how to load it without having to dial it back in. I switched over to reef crest just to see and now i cycle back to the short pulse and my settings are gone.

Any ideas?

Thanks
-Mike

Im not sure if after you save it on that mode then change modes if it will still be there. Maybe I'm wrong. But I've tried the same on my MP10 and I've had to reset it again.

Hopefully someone else chimes in cause I'm curios too