RKL programming help
I'm trying to setup my reef keeper to run a fan when my temp rises too high. I can't get it to work can anyone help?
I programmed a channel like this: Function: controller Device: iTemp Setpoint: 83.0 Hysteresis: 0.1 On when: above |
mode = auto
function = fan set point = 26.5 celsius or whatever temp you have default = off save Then change the main display to show iTemp by pressing the back button. Did you upgrade to the new firmware? |
I don't have function fan, how do I upgrade my firmware?
|
go to digital aquatics forum and d/l "Myreef". and hook it up to your PC.
|
You could set up the same way I did my chiller:
Function: Controller Device: iTemp Setpoint: 78.8 (or your desired temp) Hysteresis: 0.2 On when: Above Should kick on at 80 and off at 78.6. And don't forget to set the mode to Auto as mentioned above. I'm still on the older F/W from a year or two back. |
How do I connect to a pc? Do I need the net module?
|
You need to use the SID module and the MYReef program.
|
BLANK
|
If you go under Menu --> System --> Units, you can change the temperature to Celsius.
|
BLANK
|
All times are GMT. The time now is 11:51 PM. |
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.