Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   Reef (http://www.canreef.com/vbulletin/forumdisplay.php?f=8)
-   -   What would you do? Again with the x@#^*! Dosing (http://www.canreef.com/vbulletin/showthread.php?t=80127)

spawn 11-16-2011 05:15 PM

What would you do? Again with the x@#^*! Dosing
 
Needless to say, I am !@^&%#X choked right now. I just tested the para's for the first time since WC on sat. They have dropped from
ALK 9>7
CA 390>300
MG 1350=1350
Sal 1.026-<1.0265
I'm dosing, after a considerable drop from the last time I was whining about this...,
92 ml's of CA into 55 gal for rate of 1.67ml per gal
88 ml's of ALK into 55 gal for rate of 1.6ml per gal
Logic tells me to up the doses... but when I was dosing at a higher rate, the CA could not be maintained. So it had to be precipitating? As well the salinity was going up weekly due to the amount of supplements being added....so why add more.
I am honestly sick of &$^&#$%^ around with this, as it is a huge pain in the #%# & not fun or even the slightest bit interesting anymore. If I can't get this straightened out, I'm thinking of packing it in with this tank, & definitely reconsidering setting up a bigger one. As I have little to no faith that it will be any less of a pain in the @$@#. If anyone has anymore suggestions, I would love to hear them.

Cal_stir 11-16-2011 05:27 PM

what salt are you using?
how big a WC?

spawn 11-16-2011 05:30 PM

Reefers Best & 10 % WC. Those values were post WC. I've been doubtful of the chems because all of this seemed to start after getting my last batch of BRS.

Cal_stir 11-16-2011 05:57 PM

reefers best has 420ca and 11dkh alk so i doubt a 10% WC is causing your problem, i am dosing 60ml/d ca and 80ml/d alk using Randys 2 part instructions in a 90 gal lps reef and my params are very steady ca 430 alk 9dkh, could your test kits be screwing with you? what kind are they?how are you mixing your chems? i've used BRS chems with no probs, i always follow Randys 2 part recipe when mixing and bake the baking soda if not using soda ash for alk(baking the baking soda turns it into soda ash)which has a higher ph.

spawn 11-16-2011 06:03 PM

No it's not the WC. Alk is tested on hanna. Ca & MG are on elos. Mix chems as directed. BRS recipe 1 for the higher ph.

phi delt reefer 11-16-2011 06:07 PM

are you dosing into an area of high flow?

how much time do you leave between dosing calcium and alkalinity? You cant dose both at once.

tang daddy 11-16-2011 06:09 PM

I would have to agree aswell that a 10% WC would not effect the CA that much in a 55g tank, perhaps your sps is sucking your systems dose down. You should dose some more calcium to your system to maintain the proper levels. I currently run a 75g sps system and I am dosing 1 teaspoon of calcium powder every 2-3 days diluted in 1 liter of rodi. I dunno what that equates to with your current 2 part but it's alot of calcium.

Cal_stir 11-16-2011 06:15 PM

the brs recipe is basically the same as Randys, personnally i've had bad experiences with hanna checkers, but i have used elos and feel it is a good test kit, i use salifert and red sea now.
are u dosing all at once or using dosing pumps, dosing all at once can cause precip and dosing diff chems at the same time can cause probs to

spawn 11-16-2011 06:20 PM

Quote:

Originally Posted by phi delt reefer (Post 650994)
are you dosing into an area of high flow?

how much time do you leave between dosing calcium and alkalinity? You cant dose both at once.

Yes its into high flow, it goes though two sump chambers, then though a pump before hitting the DT. Dosing is done using the first two heads of a four head profilux. So I would guess between 15-30 mins between doses. As I've said before the paras were stable until august & @ that point I was dosing almost 4ml per gallon, which caused precip & the salinity to rise weekly while not maintaining CA levels. I can't figure it out unless the ca & mg tests are both pos. Or the ca supp. Is weak?

spawn 11-16-2011 06:59 PM

Thx tips. Read the above q & a as you are asking q's and appear not to be getting the answers.


All times are GMT. The time now is 02:36 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.