my experience with actual blades is i end up shredding the good side somehow all the time. tape or not. I'll bet my blade is old and cheap tho.

Or you could just leave the stand as it is and just paint it.

Or just follow your track record.... Sell it and start over :biggrin:

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

I own a hammer, I could help him take those walls down to get it out :razz:

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

And no a wall cannot contain my builds. The last 400 was in a wall for a very short time before I myself took a sledge to it lol. Looking back now... thank frag because I think it looks pretty hideous lol.

http://www.fishbrains.net/images/404/392.jpg

Well in that case........I will be standing by with my sledge hammer in hand waiting for the call for destruction :twised:

Well if your going to leave it open to debate.... Are you sure you are fit to decide this at any time of day?

You must BELIEVE in the power of the SCRIBE!!!

http://www.fishbrains.net/images/404/scribe4.jpg

In summary:

Going with the grain is FULL-ON-BAWLS. Removes in one strip with a much sharper edge. Heck it even sliced easier and took half the time =)

And plywood-on-end isn't even that bad for a really quick attempt.

GAME ON.