Canreef Aquatics Bulletin Board

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)
-   Reef (http://www.canreef.com/vbulletin/forumdisplay.php?f=8)
-   -   Adding acid dipped rock back to established DT (http://www.canreef.com/vbulletin/showthread.php?t=124207)

iceman86 09-08-2017 05:18 PM

Quote:

Originally Posted by smokinreefer (Post 1018105)
Thanks for the tips.

Where can one purchase the acid?

I've got a Rubbermaid full of old dried up rock I'd like to resuse.

I've seen it at all hardware stores even walmart

vanreefer 09-08-2017 06:03 PM

Quote:

Originally Posted by WarDog (Post 1018110)
Canadian Tire. In the pool section.

Or my local Rona has it too

smokinreefer 09-08-2017 06:04 PM

Thanks everyone!

maron6977 09-11-2017 04:48 PM

Can't you use vinegar, that's what I've done in the past & works great . Safer to handle.
Any advantage to the acid ?

WarDog 09-11-2017 05:18 PM

Acid completely removes the outer layer of rock. Recommended bath time is less than 30 mins, depending on your rocks density. If you leave it too long you won't have any rock left.

Vinegar just cleans the surface. So boring.

albert_dao 09-11-2017 06:25 PM

Just keep in mind that if you buy over $100 of the stuff, they're going to request and take records of an ID. Makes it SUCH A PAIN to hide your tracks after the matter.

jostafew 09-22-2017 04:50 AM

You can get the muriatic acid at Rona. I did the same thing to try to cure a phosphate with my LR. Cooked it in Acid, then neutralized the remaining acid/water combo with baking soda. RO soak, then back in the tank. No problems at all. Be warned that you'll want to do this somewhere that can handle a fountain of acidic foam pouring out of your container!

If you're going to do this, be sure to start with your container already holding the required amount of water, then add add the acid to it. Very important that you don't go the other way around.

smokinreefer 11-13-2017 02:54 AM

I'm going to be cleaning a 30G Rubbermaid full of rock...
How much baking soda should I have on hand to neutralize this?

And how do you know when it's done?

Thanks!

vanreefer 11-13-2017 05:24 PM

Quote:

Originally Posted by smokinreefer (Post 1020618)
I'm going to be cleaning a 30G Rubbermaid full of rock...
How much baking soda should I have on hand to neutralize this?

And how do you know when it's done?

Thanks!

The bubbling will be very aggressive at the beginning of the process... as far as “being done” it’s when ur happy with the appearance of the rock or the bubbling (hydrochloride acid being neutralized by the bicarbonate in the rock) slows or nearly stops... I use xtra heavy duty rubber gloves to pull out some pieces and inspect them. Please be very very very careful as the acid will burn ur skin and destroy ur clothes.
I usually put 1/2 a small box in when I’m done. More may be required if the rock was only bathed for a short time.
Remember to do this outside as the fumes are fairly intense
Good luck
VR

WarDog 11-13-2017 06:36 PM

Quote:

Originally Posted by vanreefer (Post 1020650)
The bubbling will be very aggressive at the beginning of the process... as far as “being done” it’s when ur happy with the appearance of the rock or the bubbling (hydrochloride acid being neutralized by the bicarbonate in the rock) slows or nearly stops... I use xtra heavy duty rubber gloves to pull out some pieces and inspect them. Please be very very very careful as the acid will burn ur skin and destroy ur clothes.
I usually put 1/2 a small box in when I’m done. More may be required if the rock was only bathed for a short time.
Remember to do this outside as the fumes are fairly intense
Good luck
VR

Yes safety is paramount. If you do get acid on your skin, neutralize it immediately with baking soda. I'm sure you knew that however.

I always have a few boxes open and ready to go just in case.


All times are GMT. The time now is 07:22 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.