Canreef Aquatics Bulletin Board - Center brace blocks light can I drill holes ?

Canreef Aquatics Bulletin Board (http://www.canreef.com/vbulletin/index.php)

- Ontario (http://www.canreef.com/vbulletin/forumdisplay.php?f=27)

- - Center brace blocks light can I drill holes ? (http://www.canreef.com/vbulletin/showthread.php?t=105757)

hmmm I see..... that would be cool to have a euro brace. Still seems easier to drill holes. I would have to remove all the black plastic rim that is part of the current brace.....scary

I'm no tank builder by any means buy it seems like it would be possible. Give concept a call

Quote:

Originally Posted by corpusse (Post 886976)

Many years ago when I switched from MH to T5 I was very annoyed by the shadow my center brace left. I drained the tank about halfway, cut the brace or at least 80% of it and replaced it with clear acrylic. I drilled holes in the ends of the brace and the acrylic and attached with nylon screws and nuts. Zero bowing and now it's probably been 7 years. This is in a 5 foot 112 gallon miracles tank. There is still a little bit of shadowing, probably more magnified now that I use LED lights but its much better then a black center brace.

This is exactly what I did with my 75 gallon tank years ago. Worked great.

How wide is this brace? Is there any livestock under in the shadow of it that really needs the light? If not, don't worry about it, shut off the center puck if possible & save some $$$s on electricity. If you do have something under the brace needing the light, re-aquascape or move to get it somewhere else with more light. Tank is young, now's the time to do this. No drilling, hacking, eurobracing, yada, yada, yada...

For what it's worth, my 77 gallon 4 foot Hagen tank is built without a brace, from the factory. All it has is the plastic trim around the top. It bows visibly in the center when full. For a few years I braced it using a ghetto piece of wood fix. Then I found out the tank comes this way & removed it. I had visions of the wooden brace slipping off & the sudden change in stress bursting the tank. I think the thickness of my glass is 3/8ths inch (non tempered), that's what my VorTech pump spacers are set at.