Log in

View Full Version : Acrylic Rod in Edmonton

ensquire
03-25-2011, 01:51 AM
Will be in town next week. Where can I find some acrylic rod , South side if possible.
Time to start some aquascape and want to try this method.
The Grizz
03-25-2011, 02:01 AM
The only place I know of for sure is Sabic PolymereShapes but the are on the N.W. end just off Yellowhead Trail. Google search Sabic and look under international location.
ensquire
03-25-2011, 02:05 AM
Thanks Greg, again LOL
turkleton
03-25-2011, 02:07 AM
You could also go to Johnston Industrial Plastics. They are located at 4724-91 Avenue.
The Codfather
03-25-2011, 02:51 AM
You could also go to Johnston Industrial Plastics. They are located at 4724-91 Avenue.

+1, they should have what you need.
The Grizz
03-25-2011, 03:07 AM
Thanks Greg, again LOL

No prob Mike, I was hoping someone from Edmonton or Codfather would jump in here as well as I figured he would know of other places
ensquire
03-25-2011, 03:46 AM
Thanks everybody, it's going to be a shopping frenzy next week.
Good thing for unlimited milage on the rental.
The Codfather
03-25-2011, 03:51 AM
The only place I know of for sure is Sabic PolymereShapes but the are on the N.W. end just off Yellowhead Trail. Google search Sabic and look under international location.

Ya, normally I would have said this place, but lately their prices have increased quite a bit. Getting costly for DIY projects, rod itself is very cheap, my opinion is go 3/8" for holding rock, unless it's very large, then I would go 1/2". Just make sure your creative, sometimes if you try too hard the scape looks staged. Be sure to epoxy afterwards as the rocks can in some instances spin on the rod if not secured.
ensquire
03-25-2011, 04:01 AM
what is the suggested brand of epoxy? I have a couple of tubes of twolittlefishes epoxy and I am sure it won't be near enough..
The Codfather
03-25-2011, 04:05 AM
what is the suggested brand of epoxy? I have a couple of tubes of twolittlefishes epoxy and I am sure it won't be near enough..

Seems to be the flavor of the day...
http://www.canreef.com/vbulletin/showthread.php?t=73909&highlight=epoxy
ensquire
03-25-2011, 04:08 AM
Thank you.
Kevotron
03-25-2011, 07:22 AM
Is this the marine epoxy you can use for aquariums ?

http://www.homedepot.ca/wcsstore/HomeDepotCanada/images/catalog/061083003975E_4.jpg
cale262
03-25-2011, 02:20 PM
Is this the marine epoxy you can use for aquariums ?

http://www.homedepot.ca/wcsstore/HomeDepotCanada/images/catalog/061083003975E_4.jpg


I use the Lepage 2 part putty Marine stuff...Looks, smells and tastes just like the corallife stuff from the LFS.