View Full Version : eheim 1260 making lots of noise
Milad
10-20-2010, 02:29 AM
So i have this ehiem 1260 that is on one of my skimmers. I plugged it in today and noticed its making alot of noise. Impeller needle things seem to be broken
How can i tell if the impeller is only thing broken? When I put in the impeller, it doesnt sit the in middle, it keeps touching one of the sides.
http://dl.dropbox.com/u/2361330/Aquarium%20build/H2%20A200%201260%20skimmer/IMG_0444.JPG
Skimmerking
10-20-2010, 02:42 AM
from here the pic is really blurry , but the impellar is shot and its cracked from what i see.
Milad
10-20-2010, 02:51 AM
how do i know its the impeller? if i plug the pump in by it self, its queit but i can tell something is going on.
The impeller isnt cracked, well the shaft isnt. The plast part around the shaft where the needle wheel stuff is, is cracked. I was going to mesh mod it but its making alot of noise without the top part which is cracked, removed.
Milad
10-20-2010, 02:57 AM
here are two more pics of it without the plastic needle stuff on it
http://dl.dropbox.com/u/2361330/Aquarium%20build/H2%20A200%201260%20skimmer/impeller%20and%20needle.jpg
http://dl.dropbox.com/u/2361330/Aquarium%20build/H2%20A200%201260%20skimmer/impeller.jpg
ultreef
10-20-2010, 03:07 AM
You mesh/needle wheel is broken. Which will cause an imbalance when it spins, producing a lot of vibration and noise.
Also, those metal washers I see, hope they are high quality stainless or they will eventually rush and release copper into your system. I would get them out to be safe.
Milad
10-20-2010, 03:16 AM
alright, well lucky me i have two 1260s, one was running my chiller. I pulled it out, swaped the shafts and its quiet. I guess the shaft thing needs replacing but the motor is fine.
ultreef
10-20-2010, 03:21 AM
alright, well lucky me i have two 1260s, one was running my chiller. I pulled it out, swaped the shafts and its quiet. I guess the shaft thing needs replacing but the motor is fine.
That's odd that it was the shaft. A broken shaft isn't something that you would not notice.
But I would contact the company that made your skimmer and ask about the mesh wheel. It just doesn't look right missing a big chunk of the wheel.
Milad
10-20-2010, 03:29 AM
is the shaft the magnet part or the ceramic looking skinng thing that goes down through the magnet?
the magnet part is the one that is broken it seems. I switched out the ceramic thing and it didnt make a difference
its an H&S skimmer, do they have mesh wheel? if i gota buy a new needle wheel then ill just keep it needle instead of mesh.
is there ehiem mesh wheel pre made somewhere?
Milad
10-20-2010, 03:34 AM
this is what im going to buy
http://www.finsreef.com/xcart/product.php?productid=17626&cat=286&page=1
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.